Operation Manual

NOTE :

• Unit should be installed horizontally in an

angle less than 30°.

• Before final installation into indash hole,

connect the wiring and make sure the unit is

working properly.

• Only use the parts provided with the unit to

ensure proper installation.

1. DIN Front / Rear Mount Installation

• Insert DIN frame into dash-board hole and bend mount

tabs outwards to fix it.

• If necessary, place the bracket at the rear of the unit and

fix it with provided washer and nut. Push the unit into the

DIN frame until you hear a click sound.

• Place the front ring over the unit and installation is

completed.

2. DIN Side Mount

• Installation using the screw holes on each side of

the unit. Fasten the unit with supplied screw

(M5x6) as shown figure 3.

(For this installation, front ring and DIN frame

are not required)

• Un-installation

Remove Trim Ring and insert Release Keys into left

and right side-end holes as shown figure 4 and pull

the unit out of the dash-board.

INSTALLATION

ENGLISH