User Guide

10
Bank 168-pin SDR DIMM Total Memory
Bank 0, 1 (SDR1) PC133/PC100
SDR DRAM Module
X1 64MB
∼
1.0GB
Total System Memory (Max. 1.0GB) X1 64MB
∼
1.0GB
Generally, installing SDR/DDR SDRAM modules to your motherboard is very easy, you
can refer to figure 2-4 to see what a 168-pin SDR/184-pin DDR SDRAM module looks
like.
DDR2 (BANK2+BANK3) DDR1 (BANK0+BANK1) SDR1 (BANK0+BANK1)
NOTE! When you install DIMM module fully into the DIMM socket the eject tab
should be locked into the DIMM module very firmly and fit into its
indention on both sides.
WARNING! For the SDR SDRAM CLOCK is set at 133MHz, use only PC133/
DDR266-compliant SDR/DDR Modules. When this motherboard operate
at 133Mhz, most system will not even boot if non-compliant modules are
used because of the strict timing issues, if your SDR/DDR Modules are
not PC133/DDR266-compliant, set the SDRAM clock to 100MHz to
ensure system stability.
NOTE! It is only can install either SDRAM or DDR Module at one time. Don’t
install both DDR Module and SDR Module at same time, it will have risk
to damage your Memory and Motherboard.
2-5 Expansion Cards
WARNING! Turn off your power when adding or removing expansion cards or other
system components. Failure to do so may cause severe damage to both
your motherboard and expansion cards.
2
-5-1 Procedure For Expansion Card Installation
1. Read the documentation for your expansion card and make any necessary hardware or
software setting for your expansion card such as jumpers.
2. Remove your computer’s cover and the bracket plate on the slot you intend to use.
3. Align the card’s connectors and press firmly.
Figure 2-4