User Guide

18
(7) Power switch: PWR BTN
This 2-pin connector connects to the case-mounted power switch to power ON/OFF the system.
System Case Connections
HDLED
RESET
VCC5
GN D
VCC5
PWR LED
PWRBTN
P WRBTN
PWRLED
HDDLED
RS TS W
NC
GN D
FP SPEAK
SPK
R
GN D
NC
VCC5
Pin 1
Pin 1
(8) Wake On-LAN Headers (3-pin) : WOL
This connector connects to a LAN card with a WAKE ON-LAN output. This connector
power up the system when a wake up signal is received through the LAN card.
NOTE:
This feature requires that BIOS Wake-Up by PCI Card is enabled.
Wake-On-LAN Headers
WOL
13
5VSB GND WOL
(9) FAN Speed Headers (3-pin) : FAN1, FAN2, FAN3
These connectors support cooling fans of 350mA (4.2 Watts) or less, depending on the
fan manufacturer, the wire and plug may be different. The red wire should be positive,
while the black should be ground. Connect the fan’s plug to the board taking into
consideration the polarity of connector.
FAN1
13
FAN2
13
FAN3
13