User Guide

11
CPU ZIF Socket 370
Colden Arrow
Pentium

III
Socket 370
Intel

When you put the CPU into the ZIF socket. No forces require to insert of the CPU, then press
the level to locate position slightly without any extra force.
2-3-4 Over clock Running
WARNING!
This section is for experienced motherboard installer only. Over clocking
can result in system instability or even shortening life of the processor.
After setting the Jumper JS1, JS2, JS3, JS4 you can choose over clock running by BIOS
CMOS SETUP UTILITY. When you entered CMOS SETUP UTILITY, choose
“Miscellaneous Control” you will see the screen as below then.
You can choose the situation you want to try.
CPU/SDRAM (MHz) JS1 JS2 JS3 JS4
AUTO ON ON 1-2 1-2
66/100
(Default)
OFF OFF 2-3 2-3
100/100 OFF OFF 1-2 2-3
133/100 OFF OFF 1-2 1-2
133/133 OFF OFF 2-3 1-2
CMOS Setup Utility – Copyright(C) 1984-2002 Award Software
Miscellaneous Control
Item Help
CyrixIII Clock Ratio Default
Auto Detect DIMM/PCI Clk Enabled
Spread Spectrum Disabled
** Current Host Clock is 66Mhz **
CPU Host/SDRAM/PCI Clock 66/100/33Mhz
CPU Clock Ratio X 3
Flash Part Write Protect Enabled
Menu Level >
↑↓→←
Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults
By press PageDown/PageUp key you can change the CPU Host/SDRAM/PCI Clock
When jumper setting CPU Host Clock 66MHz you can choose 66/100/33∼99/149/49MHz
When jumper setting CPU Host Clock 100MHz you can choose 100/100/33∼132/132/44MHz
When jumper setting CPU Host Clock 133MHz you can choose 133/100/33∼200/151/50MHz
When jumper setting CPU Host Clock 133MHz you can choose 133/133/33∼200/200/50MHz