Use and Care Manual

13
CHARGING THE BATTERY
Your Arrow comes with a built-in rechargeable lithium battery. Always use
the provided charger only. Before your rst ride you must fully charge the
Arrow. Charge for 12 hours for the rst 3 times you use it. The Charging Port
is located on the left side of the frame near the Handlebar Stem (see digram
on P. 4 for reference). For every ride after, charge your Arrow until it is fully
charged, and NOT LONGER. Do not leave any chargers plugged in overnight,
or leave it plugged in past the charge time.
1. Plug one end of the power cord into a grounded AC outlet and the other
into the Arrow’s charging port. The red charging light on the charger unit will
turn on.
2. The red light will turn green once fully charged. Recharge the Arrow after
each use.
(Please note: Always plug the charger into the wall rst before the device. If
the wall outlet doesn’t have power and you plug the charger into the device
rst, it will light green, even if the battery is not full. So always plug into the
wall rst to make sure there is power.)
THE CHARGER OFFERS A CHARGING STATUS ON THE TOP OF THE
CHARGER:
CHARGING LIGHT RED: Battery is charging.
CHARGING LIGHT GREEN: Charging is complete.
Charge the battery when the Arrow displays low power. When you are done
charging the battery, remember to cover the Charging Port.
Don’t use the Arrow if the battery emits strange odors, overheats, or begins
leaking. If the battery does leak, do not touch any leaking materials, as the
battery contains dangerous substances. Do not open the battery and do not
insert anything into the battery.
Only use the provided charger for the Arrow. Do not charge the battery if it
has over-discharged. It should be discarded for your safety. Do not turn on
the Arrow while it is charging.