User Manual

evo
EN
4
MEZON EVO controllers can be configured from JETI Duplex
transmitters (described below), Jetibox or USB interface with
JETI Studio application for PC (see *CM)
There are two configuration possibilities:
"Quick setup" - configuration through wizard (described below)
"Expert setting" - full access for all controller possibilities (see
*CM)
Quick setup with predefined parameters for RC model type is
normally sufficient for most users.
3.1 Configuration procedure for planes, cars and
boats models
- c h o o s e m o d e l t yp e ,
c o n t e n t o f m e n u s a r e
automatically adapted for
chosen model type
3 Configuration (setup)
Warning:
during configuration motor run is blocked for safety reasons
Basic parameters:
Start acceleration - motor
start up time from zero
revolution
Response - speed reaction
of running motor on throttle changing
Timing - set up with information from motor producer
Brake
Soft/Medium/Hard - predefined brake profiles
Manual - brake values defined by user
Proportional - brake strength depend on throttle position