Instructions

Putting into operation

Pairing with the receiver and performance verification

Any receiver and transmitter module takes advantage of digital transfer for communication purposes, in order to

enable direct address communication between the equipment it is necessary to apply the so called pairing

between them. The description of a transmitter module is given by its unique address which after pairing to the

receiver ensures, that the receiver will accept only data from this definite transmitter. There may be paired as

many receivers as you like with the transmitter module, but a receiver can be paired to one transmitter only.

Duplex transmitter modules in line with two receiers. For this

purpose you need the cable contained in the assembly kit SWTU-

2 which fits transmitters with standard connectors (for instance

the Graupner MC line). This cable is also applicable to other

transmitters but it has to be adapted to the actual transmitter

configuration or omitted altogether.

Connection of the external buzzer and earphones:

An earphone or an additional external buzzer may be connected to

the module TU2. Connection to the module TU2 is carried out by

means of the gold plated pins as shown in the picture (polarity is

of no significance). The module TU2 is able to recognize the

connection of earphones and automatically disables the buzzer

for generation of telemetric alerts. Alerts concerning loss of

range, low receiver are generated into earphones as well as into

the buzzer.

Assembly kit: Voice-1

1. Jack 3,5mm -

accessory

2. Ext. buzzer - accessory

Earphone connecting

ELECTROSTATIC SENSITIVE DEVICE

OBSERVE HANDLING PRECAUTIONS

SWTU2

JETIBOX

Earphones Buzzer

PPM