Installation Manual

CONFIDENTIAL
RF Module Installation Manual
JETCO Model JTR-01
February 27, 2019
JTR-01 RF Module - Installation Manual.docx 2019-02-27 Page
2
of 8
Labeling Requirements, Warnings, and Notices
If a JTR-01 module is placed within a separate enclosure: the following
label must be placed on the outside of the enclosure:
Contains Transmitter Module
FCC ID: 2ASF5-JTR01
No modifications may be made to the JTR-01 module:
WARNING: This module must be used as received from the
manufacturer. No modifications may be made to the power
supply, module PCB, electronics, firmware, or antenna.
Certification that the JTR-01 module complies with Part 15 of the FCC
Rules:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
Radiation Exposure Statement:
1. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
2. This equipment complies with RF radiation exposure
limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a
minimum distance of 20 cm between the radiator and your
body.