Product Manual

6
To lower forks, pull lever handle to DOWN
position (upper part of slot).
To freely move the handle, set lever in Neutral
(center notch of slot).
Figure 5
7.1 Lifting Load
1. Lower forks to lowest position, Figure 5.
2. Insert forks under load, or into pallet.
3. Place lever in UP position (bottom part of
slot), Figure 5.
4. Move handle up and down until forks reach
desired height.
7.2 Moving Load
1. Place lever in NEUTRAL position (center
notch of slot), Figure 5.
2. Pull or push pallet truck to desired location.
7.3 Lowering Load
1. Pull lever to DOWN position (upper part of
slot), Figure 5.
2. Pull forks away from load.
7.4 Up-Down Cam Adjustment
1. Set lever in NEUTRAL position, Figure 5.
2. Turn cam nut while pumping the handle,
Figure 6.
3. When lifting stops, give the nut one more
turn.
4. The cam nut is properly adjusted when
pumping the handle in NEUTRAL position
causes no movement of the hydraulic ram.
Figure 6
8.0 Maintenance
8.1 Cleaning Release Valve
Over time, the hydraulic pump assembly may
become clogged with debris or air bubbles, and
not function properly.
To clean the release valve and bleed the pump:
1. Pump handle quickly, raising pallet truck to
full extent. While continuing pumping action,
pull lever to down position.
2. When forks reach total down position, valve
is flushed. Repeat if necessary.
8.2 Lubrication
Check oil level annually by removing oil plug
found on top of pump housing. When changing
or adding oil, fill the tank through the oil plug
screw hole to 80% capacity with hydraulic jack
oil, about 2” deep in pump housing, see Figure
7. Do not use any other type of oil.
Figure 7