Replacement Part List

BRACKET REPLACEMENT
JSM-606/610/612
1. Disconnect sander from the air source.
2. Remove belt.
3. Pull out bracket in direction labeled A -
Figure 11. Be careful not to lose spring.
4. Insert new bracket by lining up pin with pin
groove. See Figure 12.
STORAGE
1. Avoid storing sander in locations with high
humidity.
2. Before storing, apply four to five drops of air
tool oil at the air inlet and run for a short
time.
SPEED ADJUSTMENT
All models have a brass'screw used for belt
speed adjustment found on the underside of
the handle. This has been set at the factory. It
is highly recommended that the end user not
attempt any adjustment to the speed control.
QIC
- Be:cke; rPdng r=\
~-cLj
Fig. 11
~
/ ~~~
//~ Pln
groove
- ~
c!" Pin
Fig. 12