Replacement Part List

2.
Remove belt (See section titled "Belt
Replacement")"
3. Remove screw(s) and remove old shoe.
4.
Install new shoe and fasten with screw(s).
Make sure insert on shoe end engages
slot on sander body.
JSM-620
1.
Disconnect sander from the air source.
2.
Remove belt (See section titled "Belt
Replacement") .
3.
Loosen hex socket cap screw (A - Figure 8).
4.
Remove old shoe. Replace with new shoe.
5. Tighten screw (A) and replace belt.
JSM-630
1. Disconnect sander from the air source.
2.
Remove belt (See section titled "Belt
Replacement") "
3. "Turn shoe holder (A - Figure 9) a quarter of
a turn with screwdriver to release shoe.
4.
Insert new shoe and turn shoe holder to
lock new shoe. Replace belt.
IDLE PULLEY REPLACEMENT
WARNING!
Disconnect the sander from the air source
before making any repair or adjustment.
Failure to comply' may cause serious injury.
Follow diagram in figure 10for your sander
model when replacing the idle pulley"
~
~
Loosen
A
w--.
1/4 TURN
Fig.8
Fig. 9
~
.~~
tighten ~..
C
\~ 1
fi
'
\ \
Loosen
JSM-610
JSM-620
JSM-630
Fig. 10