Operating Instructions and Parts Manual JCP Series Cable Pullers JET 427 New Sanford Road LaVergne, Tennessee 37086 Ph.: 800-274-6848 www.jettools.com Part No.
Warranty and Service JET warrants every product it sells against manufacturers’ defects. If one of our tools needs service or repair, please contact Technical Service by calling 1-800-274-6846, 8AM to 5PM CST, Monday through Friday. Warranty Period The general warranty lasts for the time period specified in the literature included with your product or on the official JET branded website. • JET products carry a limited warranty which varies in duration based upon the product.
.0 Safety warnings 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. Read and understand owner’s manual before operating cable puller. Do not exceed rated capacity. Supporting structure used with this device must provide adequate support to handle all puller operations plus the weight of the puller and attached equipment. If in doubt, consult a registered structural engineer. Never use handle extensions (cheaters). Do not use with twisted, kinked or damaged wire rope.
JCP Series Cable Pullers Fig. 1 A – Handle B – Forward/Reverse Latch C – Spring D – Pawl E – Wire Rope F – Locking Lever Plunger G – Locking Lever Spring H – Ratchet Wheel J – Locking Lever K – Bottom Hook L – Snatch Block (models JCP-2, JCP-4 only) M – Wire Rope Guide Bolt N – Top Hook O – Wire Rope Guide Operation 4. Release locking lever, and re-set forward/reverse latch to engage pawl with ratchet wheel and begin "winching in." Hook Positioning with No Load (Freewheel) (Fig. 1) 1.
Releasing or Lowering Load (Fig. 1) Cable puller is designed to ratchet load tension down one ratchet wheel tooth at a time: 1. While under load, place forward/reverse latch (B) to the position as shown by the dotted lines, freeing the handle (A) to move in the direction of the top hook (N). 2. As the handle nears the end of its travel, the pawl (D) is forced into contact with ratchet wheel (H), by spring loaded locking lever plunger (F) and eventually locks into one of the ratchet wheel teeth. 3.
JCP Cable Puller Trouble-Shooting Trouble Puller will not ratchet. Possible Cause 1. Broken spring (L). 1. Replace cable puller. 2. Broken ratchet tooth. 2. Replace cable puller. 3. Frame bent. 3. Replace cable puller. 1. Pawl (D) not in correct position. 1. Move forward/reverse latch (B) to position as shown by solid line. 2. Spring (L) damaged. 2. Replace cable puller. 1. Pawl not in correct position. 1. Move forward/reverse latch (B) to position as shown by dotted line. 2.
This page intentionally left blank.
427 New Sanford Road LaVergne, Tennessee 37086 Phone: 800-274-6848 www.jettools.
