Product Manual

7
2. Insert the male plug of the pendant cord into
the socket on the trolley. See Figure 4.
Secure the connection by tightening the
cover nut with your fingers.
3. Attach the pendant cord to the cord holder.
The cord must be secured to the cord holder
in a way that relieves strain on the
connections. One method of doing this is to
form a loop in the pendant cord and place
the cable tie as shown in Figure 5. Do not
tighten the cable tie yet.
4. Create sufficient slack in the pendant cord
where it passes under the I-beam (Figure 6)
so that the cord will not rub against the
beam.
5. Tighten the cable tie to secure the pendant
cord to the cord holder.
7.3 Mounting Your Hoist
This trolley has been designed to work with the
JET C-Series Hoist. They can be connected so
that one pendant cord and power cord will
operate both trolley and hoist. Make sure the
hoist has been set to the same voltage
specifications as the trolley.
Make connections from the trolley to your hoist
as follows:
1. Hang the hoist on the trolley hanger, using
hook or lug mount. (See page 8 for
instructions on installing the optional lug
mount.) The hoist should be positioned so
that the electrical socket on the trolley is on
the same side as the sockets on the hoist,
as shown in Figure 6.
2. Remove the power cord and pendant cord
from the hoist.
3. Connect the two 4P and 7P plugs of the
trolley cords into their appropriate sockets
on the hoist.
Figure 4
Figure 5
Figure 6