Product Manual

8
7.4 Installing Lug Mount Accessory
1. Assemble the side plates, hoist hanger and
lug mounting shaft, as shown in Figure 7.
2. Install the hinge plates, lock washers and
hex cap screw to secure the assembly.
3. On the electric hoist, remove the two
screws, hook pin plate, hook pin, etc.
(Figure 8)
4. Remove the top hook assembly from the
hoist, and replace it with the lug mount
accessory as shown in Figure 9. Re-install
the hook pins, hook pin plates, screws and
washers. Firmly tighten the screws.
8.0 Electrical Instructions
Electrical connections must
be made by a qualified electrician in
compliance with all relevant codes. This
machine must be properly grounded to help
prevent electrical shock and possible fatal
injury.
8.1 Grounding
In the event of a malfunction or breakdown,
grounding provides a path of least resistance for
electric current to reduce the risk of electric
shock.
This machine’s power cord must be fitted with
an appropriate UL/CSA listed plug, or it can be
“hard-wired” directly to a control panel. If hard-
wired, make sure a disconnect is available for
the operator.
If a plug is installed, it must have an equipment-
grounding conductor and a grounding prong.
The plug must be plugged into a matching outlet
that is properly installed and grounded in
accordance with all local codes and ordinances.
Do not modify the plug.
Improper connection of the equipment-
grounding conductor can result in a risk of
electric shock. The conductor with insulation
having an outer surface that is green with or
without yellow stripes is the equipment-
grounding connector. If repair or replacement of
the electric cord or plug is necessary, do not
connect the equipment-grounding conductor to a
live terminal.
Figure 7
Figure 8
Figure 9