Specification Sheet

J-A5816, 15" VARIABLE SPEED

FLOOR MODEL DRILL PRESS

115/230V 1PH

354550

These JET Drill Presses use a variable-speed motor with the stepped-pulley

system, and come equipped with a continuously variable transmission. This

enables use at a wide range of speeds, as well as the ability to change speed

during operation. A scale-marked hand wheel that matches the desired

machine speed is mounted to a reduction gearing system for precise operator

control. This adjusts the gearing ratio between the motor's fixed pulley and the

output shaft's variable pulley, changing the speed of the chuck. A tensioner

pulley is implemented in the belt transmission to take up or release the slack in

the belt as the speed changes.

Full bearing support on quill for maximum spindle stiffness

Handwheel speed adjustment of 400 to 5,000 RPM

Large 2-1/4" quill for greater accuracy

3" column diameter for maximum head support

6" stroke for deep hole application

Accurate depth stop for precice hole depths

1/2" drill chuck and arbor included

Safety collar

FEATURES

JET RED ASSURANCE 2-YEAR WARRANTY

JET warrants every product it sells. If one of our tools needs service or repair, one of our Authorized Service Centers located throughout the

United States can give you quick service. In most cases, any of these JPW Industries Authorized Service Centers can authorize warranty repair,

assist you in obtaining parts, or perform routine maintenance and major repair on your JET tools. For the name of an Authorized Service Center

in your area call 1-800-274-6848.

PAGE 1
J-A5816, 15" VARIABLE SPEED FLOOR MODEL DRILL PRESS 115/230V 1PH 354550 These JET Drill Presses use a variable-speed motor with the stepped-pulley system, and come equipped with a continuously variable transmission. This enables use at a wide range of speeds, as well as the ability to change speed during operation. A scale-marked hand wheel that matches the desired machine speed is mounted to a reduction gearing system for precise operator control.
PAGE 2
J-A5816, 15" VARIABLE SPEED FLOOR MODEL DRILL PRESS 115/230V 1PH 354550 SPECIFICATIONS Style (Type) Variable Drills to Center of Circle (in) 15 Drilling Capacity Cast Iron (In.) 5/8 Drilling Capacity Mild Steel (In.) 1/2 Distance Column to Spindle (In.) 7-1/2 Number of Spindle Speeds Variable Range of Spindle Speeds (RPM) 400 - 5,000 Column Diameter (In.) 3 Spindle Taper (In. x TPI) MT-2 Spindle Travel (In.) 6 Spindle Distance to Base (In.) 44-1/2 Spindle Distance to Table (Max.) (In.