Product Manual

PT Series Manual Trolley – Installation and Safety Instructions

JET Manual Trolleys are designed to be used on either "Ι" or “H” wide flange beams.

JET PT Series Trolleys comply with OSHA regulations, ANSI/ASME B30.11 and B30.17 standards.

1. Beam must be properly installed and rated for anticipated loads.

2. Do not install trolley on beams of unknown capacity.

3. Do not install trolley on damaged or deformed beams.

4. JET trolleys are designed to be used with hoists of the same rated capacity. Never use a hoist with a capacity

greater than the capacity of the trolley.

5. Never subject trolley to a side pull or load. Load must be centered directly under the hoist / trolley assembly.

6. Make sure load is stable and secure before moving.

7. Never lift load more than is necessary to safely move it.

8. Always follow installation instructions.

9. Do not use if under the influence of drugs, alcohol, or medication.

Installation Instructions

(refer to drawing at right)

1. Trolley must be installed on a beam with a

minimum clearance (wheels to flange) of 1/16" to

a maximum of 1/8". Reference "A" on both sides

of the beam.

2. To extend trolley width, remove split pins and hex

nuts. Remove washer spacers from center bolt

and place between hanger bracket and fixed

spacer. Note: Washer spacers must be moved in

sets of two, one on either side of the hanger

bracket, as the hanger bracket must always

remain centered between the trolley side plates.

3. Once trolley width is spaced properly, install

remaining washer spacers on the center bolt

(same number on both sides) on the outside of the

side plates. Install hex nuts and split pins. Do not

over tighten nuts. Tighten nuts and then back

nuts off to align the nut with hole in shaft for split

pin. Insert split pin through each hex nut and bend

one end of split pin.

4. Re-check wheel clearance "A" and re-adjust if necessary.

WALTER MEIER (Manufacturing), Inc.

427 New Sanford Road

LaVergne, Tennessee 37086 Part No. M-252005

Ph.: 800-274-6848 Revision B 04/2013

PAGE 1
PT Series Manual Trolley – Installation and Safety Instructions JET Manual Trolleys are designed to be used on either "Ι" or “H” wide flange beams. JET PT Series Trolleys comply with OSHA regulations, ANSI/ASME B30.11 and B30.17 standards. 1. 2. 3. 4. 5. 6. 7. 8. 9. Beam must be properly installed and rated for anticipated loads. Do not install trolley on beams of unknown capacity. Do not install trolley on damaged or deformed beams.
PAGE 2
PT Series Trolley: Specifications and Parts List Capacity Stock No. 1/2 Ton 252005 1 Ton Beam Flange Width “G” (min–max) Beam Height (min-max) Min. Radius Curve Shipping Weight mm 64–203 76–622 900 in. 2-1/2–8 3–24.5 mm 76–203 in. A B C (Ø) D E (Ø) F G H J 8.5 (kg) 212 312 58 130 82 102 64–203 113 24 35 19 (lb) 8.35 12.28 2.28 5.12 3.23 4 2-1/2–8 4.45 0.95 127–622 1000 15 (kg) 252 330 75 155 102 118 76–203 128 30.5 3–8 5–24.5 39 33 (lb) 9.