Operating Instructions and Parts Manual Hydraulic Stacker Model JHS-2200A JET 427 New Sanford Road LaVergne, Tennessee 37086 Ph.: 800-274-6848 www.jettools.com Part No.
1.0 Warranty and Service ® JET warrants every product it sells against manufacturers’ defects. If one of our tools needs service or repair, please contact Technical Service by calling 1-800-274-6846, 8AM to 5PM CST, Monday through Friday. Warranty Period The general warranty lasts for the time period specified in the literature included with your product or on the official JET branded website. • JET products carry a limited warranty which varies in duration based upon the product.
2.0 Table of contents Section Page 1.0 Warranty and Service ..................................................................................................................................... 2 2.0 Table of contents ............................................................................................................................................ 3 3.0 About this machine and manual .....................................................................................................................
.0 Safety warnings 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. Read and understand all warnings and operating instructions before attempting to use the stacker. Replace warning labels if they become obscured or removed. Do not exceed rated capacity. Excessive load can cause tipping or loss of control. Do not exceed load center capacity of stacker. Load center is measured horizontally from back of forks or platform. See Figure 1. The load center (A) is 20-inches on the JHS-2200A Stacker.
.0 Specifications Model number ............................................................................................................................... JHS-2200A Stock number ...................................................................................................................................... 140531 Capacities and forces: Load capacity .......................................................................................................................
.0 Setup and assembly 7.0 Operation Number in parentheses refers to corresponding number in parts breakdown. 1. Remove all packing material from stacker. 2. To assemble forks, remove one of the snap rings (#5). Tap fork shaft out (#6). Forks to be assembled must come from the same crate as the mast. 3. Align holes in forks (#1) with holes in carriage (#4) and tap fork shaft through carriage and fork holes. 4. Reinstall snap ring (#5) to hold fork shaft in place. 5.
9.0 Troubleshooting JHS-2200A Hydraulic Stacker Number in parentheses refers to corresponding number in parts breakdown, section 10.1.1 Trouble Probable Cause Remedy Fork will not lift to maximum height. Hydraulic oil level is low. Fill with hydraulic oil. Oil level is low, or oil is too viscous. Fill with oil, or change oil. Oil has impurities. Change oil. Hex nut (#62) is too high, keeping the pumping valve open. Adjust hex nut properly. Air in hydraulic pump.
10.1.
10.1.2 JHS-2200A Mast Assembly – Parts List Index No Part No Description Size Qty 1 ................ JHS2200-1 ................ Fork.......................................................................... ...................................... 2 3 ................ JHS1100-2 ................ Adjusting Screw ....................................................... ...................................... 2 4 ................ JHS2200A-4 .............. Mounting Plate .........................................
Index No Part No Description Size Qty 59 .............. JHS2200A-59 ............ Release Rod ............................................................ ...................................... 1 60 .............. JHS2200A-60 ............ Chain ....................................................................... ...................................... 1 61 .............. JHS2200A-61 ............ Anchor Bolt .............................................................. .................................
10.2.
10.2.2 JHS-2200A Pump Assembly – Parts List Index No Part No Description Size Qty .................. JHS2200A-PA ........... Pump Assembly (includes #86-133) ........................ ........................................ 86 .............. JHS1100-86 .............. Bolt........................................................................... ...................................... 1 87 .............. JHS1100-87 .............. Spring Cap ...............................................................
