OWNER’S MANUAL XACTA FENCE II™ Commercial 30/50 JET EQUIPMENT & TOOLS, INC. A WMH Company www.jettools.com P.O. BOX 1349 Auburn, WA 98071-1349 e-mail jet@jettools.
Important Information 2-YEAR JET offers a two-year limited warranty on this product LIMITED WARRANTY REPLACEMENT PARTS Replacement parts for this tool are available directly form JET Equipment & Tools. To place an order, call 1-800-274-6848. Please have the following information ready: 1. Visa, MasterCard, or Discover Card number 2. Expiration date 3. Part number listed within this manual 4. Shipping address other than a Post Office box.
XACTA FENCE II™ COMMERCIAL 30/50 Note: This manual also runs through the steps of installing the rails, and extension table.
2. Place a leg bracket into the outboard end of the table. Assembly Note: To insure that you have enough adjustment in the cursor during the final adjustments, at this time you should bolt the guide rail to the front rail with two hex cap screws. Place the fence on the guide rail so that the cursor lines up at four inches. Measure from the saw blade to the fence and adjust the front rail so that you are as close to four inches as possible. You do not have to adjust the cursor at this time.
Guide Rail Assembly Note: You may need to re-adjust the clamping pressure after aligning the fence. 1. Bolt the guide rail to the front rail with 1/4-20 x 3/4” hex cap screws 1/4" flat washers and 1/4" lock washers. Center the bolt heads in the slotted holes of the rail so you will have some lateral adjustment. Clamping Pressure The XACTA FENCE II™ has been adjusted at the factory to lock securely when the lock handle is pushed down. If adjustment is needed: 2.
90°° to the Table 1. Place the fence on the saw table and lock it. 2. Place a square on the table next to the fence. The fence should be 90° to the table, Figure 6. 3. If adjustment is necessary, unlock the fence, and turn one of the two nylon adjustment screws (A, Fig. 7) until the fence is 90° to the table. 4. Lock the fence and check the adjustment again. Cursor Adjustment 1. Disconnect the table saw from the power source. 2. Raise the saw blade above the tabletop. 3.
Parts List for the JET XACTA FENCE II™Commercial 30/50 Index Part No. No. Description Size Qty. 1..........XF-1................................. Side Plate...................................................... ................................... 2 2..........XF2-2W ........................... Fence Body Assembly ................................... ................................... 1 3..........XF2-3............................... Pad Set ......................................................... ......
Parts Breakdown 8
