Owners Manual

Installation F-18 , continued

ELECTRICAL

A 208-240 volt, 60 Hz, Single Phase circuit is required

for this unit. Check the rating plate on the front of the

machine for the amp draw. In spite of the fact that the

rating plate shows 220 volts, the unit is designed

function properly on 208 volts to 240 volts.

The top & back panels must be removed for the

electrical hook -up. The top panel is secured by two

Phillips head screws. Once the screws are removed,

the panel should be slid to the back and lifted. The

back panel is also held by two screws. Remove them,

pull the bottom away from the machine and lift the

panel.

The terminal block is located inside the back cover. Pass the cable through the cable strain relief and

connect the wires to the terminals L1 (brown wire), L2 (blue wire) & Ground (yellow & green wire). Replace

the top & back panels being careful not to pinch or kink any

wires or hoses. There should be sufficient cable length to

permit the machine to be pulled out for service.

IMPORTANT NOTE

Reasonable access to and around the machine for

service must be provided. Disconnecting of hard

plumbing or removal of counter tops or cabinets, etc., for

servicing is not covered by warranty.

DO NOT fill dishwasher manually with water. The

dishwasher will fill automatically when the power is

turned on.

ater

Out

All panels must be replaced on the unit when the installation is completed.

* - not supplied