Use and Care
Connecting your new F-16DP
This glasswasher must be installed on a level, rigid, nonflammable
surface. Ensure that the machine is level by installing the feet
(shipped in the wash tank of the machine) and adjusting the leveling.
Be sure to provide adequate space for water, drain and electrical
connections.
**WATER SUPPLY**
A 3/4”NPT fitting is required with 30 psi. dynamic pressure. A water
pressure regulator* may be required. The water pressure cannot be less
than 30 psi or exceed 30 psi. If the water pressure exceeds the
prescribed amount, you will get inconsistent washing temperature,
premature failure and thus may void the warranty.
Incoming water temperature must be 140ºF (60ºC). An easily
accessible shut-off valve is recommended, making installation, service and
maintenance easier. A flexible fill hose is provided to make installation, servicing
and maintenance easier.
Make sure that the water is free from calcium and hard water deposits. For these
situations, an inline water cartridge system is highly recommended. Build-up of
calcium and lime deposits in the washer may occur and servicing will be required
on a more frequent basis which will not be covered by the warranty.
**DRAIN**
·
F-16 DP: This glasswasher is equipped with an automatic drain
pump that will pump the drain water to a maximum height of 36" (0.9
meter). Drain pump equipped machines have a white button on the
control panel beside the green power button.
1" ID flexible drain hose is provided to facilitate maintenance and servicing of the
machine. It is important not to reduce the size of this hose. A 1" check-valve* may be
required. .
ELECTRICAL
L1
A 208-240 volt, 60 Hz, Single Phase circuit is required for this unit. Check the
rating plate on the machine for amp draw. In spite of the fact that the rating
plate shows 208 volts, the unit is designed function properly on 208 volts to
240 volts.
The terminal block is located at the back of the machine. Open the plastic
cover, pass the cable through the cable strain relief and connect the wires to
the L1, L2 & Ground. There should be sufficient cable length to permit the
machine to be pulled out for service. DO NOT turn on the power to the
machine until the water supply & drain lines have been connected. DO NOT
manually fill wash tank. It will fill automatically.
W
ater
In
L2
IMPORTANT NOTE
Reasonable access to and around the machine for service must be provided.
Disconnecting of hard plumbing or removal of counter tops or cabinets, etc., for
servicing is not covered by warranty.
* - not supplied
All panels must be replaced on the unit when the installation is completed.
W
ater
out
* - not supplied
** SEE PAGE 6 FOR FURTHER IMPORTANT DETAILS**
8