Use and Care

Connecting your new F-14

This dishwasher must be installed on a level, rigid, nonflammable surface. Ensure

that the machine is level by installing the feet (shipped in the wash tank of the

machine) and adjusting the leveling. Be sure to provide adequate space for

water, drain and electrical connections. The rear panel must be removed for the

hook ups and must be replaced after the connections are made.

ELECTRICAL SUPPLY

A 115 Volt - 20 Amp circuit breaker is required for this washer. A power-

cord with NEMA 5-20 plug is provided for your convenience.

**WATER SUPPLY**

A 3/4” NPT coupling is required with 30 psi. dynamic pressure. A water

pressure regulator* may be required. The water pressure cannot be less

than 30 psi or exceed 30 psi. If the water pressure exceeds the prescribed

amount, you will get inconsistent washing temperature, premature failure and

thus may void the warranty.

Incoming water temperature must be 140º F (60º C). An easily accessible shut-

off valve is recommended, making installation, service and maintenance easier.

A flexible fill hose is provided to make installation, servicing and

maintenance easier.

Make sure that the water is free from calcium and hard water

deposits. For these situations, an inline water cartridge system is

highly recommended. Build-up of calcium and lime deposits in the

washer may occur and servicing will be required on a more

frequent basis which will not be covered by the warranty.

**DRAIN CONNECTION**

This washer has a gravity type drain. Since this unit is a “Counter-

Type” installation, the flexible drain hose provided should be

connected to the drain outlet elbow at the rear of the unit behind the

rear access panel; and extended through the side opening directly

into a floor drain or

sink (see Figure )

All panels must be replaced on the unit when the

installation is completed.

DO NOT

manually fill wash tank with water. The dishwasher will fill

automatically when the power is turned ON.

Electrical

Drain

outlet

ater

inlet

connection

* - not supplied

** SEE PAGE 6 FOR FURTHER IMPORTANT DETAILS**