Use and Care

suds as possible. Leave overflow >>Verify all connections.
out, close the door and put power
on. Let unit run for 2 to 4 minutes. >Verify that power is going to the
Turn off unit, put overflow back in, machine.
close the door and refill unit. Try >>Verify the breaker or fuses. Verify
washing. If reoccurs try from the electrical connections to the
beginning again. machine.
>The solenoid valve may have dirt
in it or may be defective.
5. Does not wash properly
>>Clean the filter or replace as
required.
>Are the scrap screens clean?
>>Clean the scrap screens & filters.
4. Does not operate or start
Don't forget the wash pump screen.
>The door micro switch may be >Are the wash/rinse arm jets
defective. clogged?
>>Adjust switch. Some of the parts >>Clean the jets/nozzles. Be
may have to be replaced. careful not to lose the o-rings.
>The momentary relay may be >Detergent system may be
defective or disconnected. defective.
>>All wires must well in place. If so >>Peristaltic hose(s) may have to
replace it. be replaced. The detergent filter in
the container may be clogged or
>The power switch may be worn. Replace. Check the detergent
unplugged or defective. line for deposits. Clean the line if
>>Verify connections and replace necessary.
as required.
>Dishes appear dirty after the cycle
>The pressure switch may be faulty. is completed.
>>Adjust switch. Replace as >>Pre-rinse the dishes properly
required. before they are placed into the dish
racks.
>The solenoid valve may have dirt
in it or may be defective. >Drain outlet hose may be blocked.
>>Clean filter or replace as Drain pump may be blocked or
required. defective, and is not allowing proper
drainage of machine.
>The timer may be defective. >>Un-clog, reposition hose or
>>Replace. change drain hose. Un-clog or
replace drain pump, as required.
>The washing cycle button may be
defective. >Incoming water pressure may be
>>Replace. either too low or too high will result
in poor rinsing.
>The wiring may have a break or >>If the pressure is too low (under
short to ground. 20 psi), check that the valve is fully
29