Use and Care

IMPORTANT NOTES:

-The

models

F-22,

747

and

767

differ from the under-counter units in the way

to initiate the wash cycle. Once the unit has filled up with water and the

temperatures have reached their maximums, slide the basket in and close the door.

Closing the door will start the wash cycle. At the end of the cycle, after the cycle

light has switched off, open the door and remove the basket. The cycle light will

come on at that point for a few seconds to reset the timer for the next wash.

- JET-TECH high temperature warewashers do not dump water and fill after every

cycle. The wash water is refreshed during every cycle by the hot

rinse water. Only excess water is expelled from the machine via the overflow

pipe. If the wash water becomes soiled, it is recommended turn off and drain the

dishwasher, clean

all debris from the filters and wash tank and turn on the dishwasher to

fill with fresh water

- Some models are equipped with an automatic drain pump (White button on the

front control panel) that will evacuate excess water. Please see the section

on: DRAIN PUMP OPERATION.

- During the rinse cycle, verify that Rinse Pressure is 30 PSI and that

the Chemical Flow Indicators are moving.

- IMPORTANT: If the dishwasher will not be used for two (2) or more hours, it should

be drained and turned off. The dishwasher should never be left in the “ON” position

and unattended.