Use and Care

CHEMICAL PUMPS

Models 727, 737, 747, 767, F-14, F-16DP, F-18, F-18DP, F-20 & F-22 are supplied with

factory installed liquid detergent and rinse additive pumps to automatically dispense during

each wash & rinse cycle. Before accessing the bottom section of the dishwasher, make sure

that the power is turned off at the

source (breaker panel).

The bottom panel can only be

removed with a flat tool like a screw-

driver. Insert the screw-driver in the

gap between the front panel and the

side panel. Pry open towards you.

Do this on both sides.

The red & blue hoses connected to the pumps must be routed out of the

bottom of the dishwasher. The red tube is for detergent and the blue tube is for

rinse additive. The containers can be either to the right or left of the

dishwasher. Perforating the stainless panel is not recommended.

The two chemical pumps are factory adjusted to accommodate most installations.

There is a mark on the pump indicating this setting.

It is recommended that only qualified personnel alter these settings.

UNDER NO CIRCUMSTANCES should the detergent pump be

turned off.

RINSE ADDITIVE

BLUE TUBE

DETERGENT

RED TUBE

F-18DP