Use and Care

Connecting your new 767
This dishwasher must be installed on a level, rigid, nonflammable surface. Ensure that the
machine is level by installing the feet (shipped in the wash tank of the machine) and adjusting the
leveling. Be sure to provide adequate space for water, drain and electrical connections.
**WATER SUPPLY:**
A 3/4” NPT fitting is required with 30 psi. dynamic pressure. A water pressure regulator* may be
required. The water flow pressure cannot be less than 30 psi or exceed 30 psi. If the water pressure
exceeds the prescribed amount, you will get inconsistent washing temperature, premature parts
failure and thus may void the warranty.
Incoming water temperature must be 140º F (60º C).
A flexible drain hose is provided to make installation, servicing and maintenance easier.
Make sure that the water is free from calcium and hard water deposits. For these situations, an on-
line water cartridge system is highly recommended. Build-up of calcium and lime deposits in the
washer may occur and servicing will be required on a more frequent basis which will not be
covered by the warranty.
**DRAIN**:
This dishwasher has a gravity drain. Maximum height of the drain should not exceed 20" (50cm).
A 1.5" ID flexible drain hose is provided to facilitate maintenance and servicing of the
machine.
ELECTRICAL:
A 208-240 volt, 60 Hz, Single Phase or Three Phase circuit is required for this unit. Check the
rating plate on the machine for amp draw and phase. Pump rotation must be verified on 3 phase units
at time of install. In spite of the fact that the rating plate shows 208 volts, the unit is designed
function properly from 208 volts to 240 volts.
The terminal block is located under the control panel, inside the machine. Pass the cable through
the cable strain relief at the back and connect the wires to the terminals L1 (brown wire), L2 (blue
wire), L3 (black wire) & Ground (yellow & green wire). There should be sufficient cable length to
permit the machine to be pulled out for service.
DO NOT
manually fill wash tank with water. The dishwasher will fill
automatically when the power is turned ON.
IMPORTANT NOTE
Reasonable access to and around the machine for service must be provided.
Disconnecting of hard plumbing or removal of counter tops or cabinets, etc., for servicing
is not covered by warranty.
Verification of the pump rotation is very important!
All panels must be on the unit when the installation is finished.
* - not supplied
** SEE PAGE 6 FOR FURTHER IMPORTANT DETAILS**
17