Use and Care

Connecting your new F-22
This dishwasher must be installed on a level, rigid, nonflammable surface. Ensure that the
machine is level by installing the feet (shipped in the wash tank of the machine) and adjusting the
leveling. Be sure to provide adequate space for water,
drain and electrical connections.
**WATER SUPPLY:**
A 3/4” NPT fitting is required with 30 psi. dynamic
pressure. A water pressure regulator* may be
required. The water flow pressure cannot be less than
30 psi or exceed 30 psi. If the water pressure exceeds
the
prescribed amount, you will get inconsistent
washing temperature, premature parts failure and
thus may void the warranty.
Incoming water temperature must be 140º F (60º C). An easily accessible shut-off valve is
recommended, making installation, service and maintenance easier.
A flexible drain hose is provided to make installation, servicing and
maintenance easier.
Make sure that the water is free from calcium and hard water deposits. For
these situations, an inline water cartridge system is highly recommended.
Build-up of calcium and lime deposits in the washer may occur and servicing
will be required on a more frequent basis which will not be covered by the
warranty.
**DRAIN:**
This dishwasher has a gravity drain. Maximum height of the drain should not exceed 20" (50cm).
A 1.5" ID flexible drain hose* is recommended to facilitate maintenance and servicing of the
machine.
ELECTRICAL:
A 208-240 volt, 60 Hz, Single Phase or Three Phase circuit is required for this unit.
Check the rating plate on the machine for amp draw and phase. In spite of the fact
that the rating plate shows 208 volts, the unit is designed function properly from 208
volts
to 240 volts.
The terminal block is located in the control box on the side of the unit. The
faceplate of the control panel pulls out, exposing the terminal block, after the
screws are removed. Pass the cable through the cable strain relief at the back and
connect the wires to the terminals L1 (brown wire), L2 (blue wire), L3 (black wire) &
Ground (yellow & green wire). There should be sufficient cable length to permit the
machine to be pulled out for service.
DO NOT
manually fill wash tank with water. The dishwasher will fill automatically when the power is turned ON.
IMPORTANT NOTE
Reasonable access to and around the machine for service must be provided.
Disconnecting of hard plumbing or removal of counter tops or cabinets, etc., for servicing
is not covered by warranty.
All panels must be on the unit when the installation is finished.
* - not supplied
** SEE PAGE 6 FOR FURTHER IMPORTANT DETAILS*
12