Manual
SECTION 4 INSTALLATION
4.1 Removal from packing and positioning:
Make
sure
that
the pot washer is in perfect condition. In case of damage, you must immediately contact the
freight forwarder. In case of doubt concerning the pot washer condition,
have
the unit
checked
by
an
authorized
service
centre before being put into use.
The
installation
must
be
performed
exclusively
by
qualified
technicians,
according
to
the
JET-TECH’s
instructions.
Move
the
pot washer
where
you
wish
to
install
it
and
remove
the
packing.
This
pot washer
is
designed
for
fixed
connections
only.
Position
the
pot washer
on
a
flat
surface.
Install
electrical,
water
and
drain
lines
in
the
washing
area
according
to
the
instructions
provided
on
the
machine's
technical
data
sheet.
Further
details
are
indicated
in
the
paragraphs
relative
to
plumbing
and
electrical
connections.
Before connecting the pot washer to the water and electrical supply, please consult the data plate on the pot
washer. All services on site must be in compliance with the pot washer requirements.
The
floor
must
be
measured
taking
the
overall
weight
of
the
machine
into
consideration.
It
must
also
be
perfectly
flat.
NOTE:
to
connect
the
pot washer
to
work
tops,
couple
the
supports
on
the
edges
of
the
tank
and
fix
them
using
the
screws
provided.
The
connection
can
be
either
on
the
front
or
side.
4.2 Electrical connections :
“The pot washer shall be installed in accordance with local codes, or in the absence of local codes, installed
in accordance with the applicable requirements in the National Electrical Code, NFPA 70, Canadian
Electrical Code (CEC), Part 1, CSA C22.1, and Standard for Ventilation Control and Fire Protection of
Commercial Cooking Operations, NFPA 96”
When
connecting
the
pot washer
to
the
power
supply,
refer
to
the
wiring
diagram
and
the
data
plate
of
the
pot washer.
Make sure that the voltage and frequency of the power supply correspond to those on the plate indicating the
technical
characteristics
located
on
the
right
side
of
the
machine.
Install
a
“main
switch”
(not
provided)
on
the
electrical
line
that
supplies
the
pot washer
in
compliance
with
the
requirements
of
the
local
electrical
standards.
The incoming power cable from the main switch (not provided) will be connected to the terminal
block located inside the machine.
The
power
cable
must
be
rated
for
at
least
165
°
F (
75°C).
The
power
cable
must
be
copper
conductors
only.
Before
the
supply
connections
check
minimum
supply
conductor
amp capacity
(see
label
near
the
terminal
block).
Before
the
supply
connections
check
m
aximum
rating
of
supply
overcurrent- protective
device
(see
label
near
the
terminal
block)
An
effective ground connection in conformity with
the
prevention
standards
is
required
for
operator
safety
and
equipment.
On
the
three-phase
models,
check
for
correct
rotation
of
the
wash
pump.
8