2.
A. Checking Contents of Box Ƶ Important-Safety Precautions x To prevent fire or shock hazard, do not expose this device to rain or moisture. Does not use near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool. x To avoid electrical shock, do not open this device. x This device should be operated to use only the power supply included with it or provided as an accessory.
B. Introduction to 2.4GHz Digital Wireless A/V Sender Congratulations on purchasing this 2.4GHz Digital Wireless A/V Sender. This sender system is a digital wireless audio/video sender that uses 2.4GHz Frequency Hopping technology and GFSK modulation, and random ID codes to protect personal privacy. There are over billion hopping sequences to minimize interference and deliver consistently an excellent video and audio quality up to 100 meters away.
device with clothes or other things. l C. Product Layout REAR VIEW FOR RECEIVER CH4 (NTSC only) The following illustrations and show the names of each component, button and switch connectors on the transmitter and receiver. RF output to TV (e.g.2058R) FRONT VIEW TRANSMITTER 2.
with the following instructions to the matching code. Please see the follow pairing operation. 1. The first, push the power switch of transmitter and receiver and turn on both power switch. Then you can press the PAIR button on the front of the transmitter and not release until the LINK LED on the front of the transmitter begins to flash then you can release the PAIR button, and then the transmitter starts to enter the pairing state and automatically link ID code to the receiver. 2.
If your VCR has only SCART socket for audio/video output, you can use a SCART/RCA adapter (not included) to connect the RCA plug of the transmitter and the SCART socket of VCR. Please follow the instruction figure below. 1. Plug one end of the power adapter into the back of the transmitter and the other end into any AC wall outlet. Use only the adapter provided. 2. If you VCR have only one set of A/V output jacks and you want to use it with a nearby TV.
· Connect the receiver directly to the remote TV. · Connect the receiver to a VCR, which is then connected to the TV. If your TV has picture-in-picture capabilities, you can view any image transmitted by sender, such as your sleeping baby, in a small inset picture while enjoying other programming on the rest of the screen. Consult the owner's manual of your TV for instructions on using these capabilities.
source using your existing remote control device. It converts the infrared (IR) signal emitted by your remote control to a radio frequency (RF) signal in the receiver and sends it back to the transmitter where the RF signal is converted back to the original IR signal and control the audio/video source such as DVD ,VCR , etc.
Problem No picture or sound Interference: picture or audio Remote control extender does not work Possible solutions x Check all cable connections. x Make sure power plugs are pushed all the way in. x Check power switches on the remote TV and Video source. (VCR, laser disc player, satellite receiver, ect. ) x Check the power on/off switches on the transmitter and receiver. x Check if the LINK LED of the transmitter and receiver is lighting or not? Their LINK LED should be lit.
