User's Manual

Note2:

Jesmay 0703

■

How To Receive Wireless Audio/Video Signals on Your TV

or monitor

1. Just plug into the RCA or SCART output port of TV or Monitor. If you

use receiver with RCA plugs the yellow, red and white plugs have to

match the yellow, red and white port of TV or Monitor

Plug one end of the power adapter into the back of the transmitter and

the other end into any 230-volt wall outlet (or 120-volt).

Note: use only the adapter provided.

Note1:

You can use T type scart adapter jesmay Model No.8218T

(optional) for various installations. This is designed with 2 scart jacks and 1

scart plug and input/output switch.

Note2:

You can use Wall mounting jesmay Model No.0703 (optional) and

a connect cable for connecting AV sender and monitor or DVD etc.

■ How to Use the IR Extender mouse

The IR extender connects to the transmitter through its own special

connector plug. The extender emits an IR signal can control your A/V

equipment with the remote signal. To use the IR extender, follow the

instructions below:

1. Plug the IR extender mouse into the 2.5mm phone jack of the side of

transmitter.

Note: the jack to the IR extender mouse is marked as “IR-T”.

2. Locate the IR sensor on the IR receiver window of source A/V equipment

you wish to control.

DVD/VCR/SAT

IR sensor

Fig-5

3. You have 3 more IR receiver of you disposal to control 3 additional A/V

equipments.

4. Locate the IR sensor on the side of TV or Monitor where you can

remote control and point remote control at IR sensor.

Desktop 42" TFT Monitor

Wall Mounting 42" TFT Monitor

Note1:

Jesmay 8218T