User's Manual

B. Introduction to 2.4GHz Wireless Plug In AV SENDER
This sender system is a wireless audio/video sender that uses advanced
wireless communication technology to deliver consistently sharp audio and
video up to 100 meters away. By transmitting at a very high frequency (2.4
GHz), it avoids the crowded 900 MHz band used by many cordless
telephones and other wireless audio/video transmitters. It
’s superior quality
is due to wide-band FM rather than AM signal modulation.
It also integrates an UHF remote control extender to allow you to control
the audio or video source from another room using your existing remote
controller.
Using sender system, you can enjoy greater convenience and security in
many ways:
General Application
• Watch the movie you rent on any TV in house without moving your VCR,
laser disc player or running messy cables.
• Watch cable or satellite programs on any TV in house.
• Listen to stereo-quality music from your receiver on any powered
speakers inside or outside the house.
• Uses multi-receivers for broadcasting to numerous TV sets in other rooms.
• Show computer images on a remote TV. (Additional equipment required)
Safety & Security Application:
• Applies as a wireless security system.
• Monitor your sleeping baby, playing children, the elderly, or the disabled
on TV using your existing camcorder.
• See who is outside the door on TV through your camera or miniature
CCD camera.
• Monitors and records meeting from another room.
• And many more uses!
3
■
The Using Attention
1. The outlet of the power supply must have the same voltage as the local
area.
2. Be sure the transmitter and the receiver were connected to the equipm
ent correctly (e.g. Connect the transmitter to the VCR, and the
receiver to the TV).
3. When turning off from transmitter or receiver, it needs to wait for a few
seconds in order to restart again.
4. In most situations, one set of equipment has a better feature within 100
meter. When two sets or more is used at the same time, you have to
use different channels. But a transmitter can be used with several
receivers at the same time.
5. The channel selectors allow you to change the channel for best feature
and least interference.
6. When the equipment is operating, please do not use a microwave oven
near by.
7. The remote control should face to IR extender mouse on receiver, and
the IR extender mouse on transmitter should be set and face to the IR
receiver window on the source A/V equipment. The IR remote have to
within the receivable distance.
C. Panel Controls and Features
The following illustrations show the names of each component,
button and switch connectors on the transmitter and receiver.
4