User's Manual

■ Important-Safety Precautions
This device of which operation is subject to the following two conditions
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
• To prevent fire or shock hazard, do not expose this device to rain or
moisture.
Do not use near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet
basement, or near a swimming pool.
• To avoid electrical shock, do not open this device.
• This
device should be operated to use only the power supply included
with it or provided as an accessory.
• Do not overload wall outlets and extension cords as this can result in the
risk of fire or electrical shock.
• Do not attempt to service this device yourself. Refer servicing to qualified
personnel only.
Caution:
Changes or modifications not expressly approved by the
Party responsible for compliance could void the user
’s authority to
operate the equipment.
■ Note:
This equipment has been tested and found to comply with part 15 of the
FCC Rules or R&TTE directive. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy, if not installed and used in accordance with the
instruction, it may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help
.
1
A. Checking Contents of Box
Checks to make sure that all of the items shown as below are included with
your 2.4 GHz Wireless Plug-In AV SENDER System. If something is
missing, please contact your dealer as soon as possible.
1. Transmitter
×1
2299T
2.Receiver ×1
2299R
3. Power adapter (optional ！
×2
□ (230VAC to 7.5VDC) or
□ (120VAC to 7.5VDC)
DC in Jack ( 7.5V 300mA)
4. IR extender mouse (emitter sensor) ×1
connect to transmitter
's IR extender port.
(IR-T)
5. IR extender mouse (receiver sensor) ×1
connect to receiver
's IR extender port.
(IR-R)
6. Double jacks to one plug T type scart adapter
Jesmay 8218T (optional)
7. Wall mounting
Jesmay 0703 (optional)
SCART to SCART cable
Jesmay 9982J (optional)
8. Owner’s manual
×1
2