User's Manual

N.O.: Normally open type. It means that in the normal state, the sensor device is kept under

constant low voltage. If output voltage changes from low to high, then the alarm is triggered.

N.C.: Normally closed type (also – “normally connected”). The normal state of the sensor

device is under constant high voltage. If output voltage changes from high to low, then the

alarm is triggered.

OFF: Set to “Off” if you are not going to use external sensor alarms.

OUTPUT: “ON” indicates that an alarm will go on if it had been triggered by sensor.

RECORD: “ON” indicates that the relevant channel will record if it had been triggered by

sensor.

BUZZER: “ON” indicates that the buzzer will turn on if it had been triggered by sensor.

Prerecord: “ON” indicates that the relevant channel will prerecord 5 seconds if it had been

triggered by sensor.

Email: “ON” indicates that the picture of relevant channel will be send to mail if it had been

triggered by sensor.

Note˗If the output time, record, buzzer,

prerecord and Email had been turned off, the

relevant option will not be triggered in any

case.

5.6.7 Motion Detection

The Tool Bar

System Setting

Alarm

Motion

[>>] button will bring up the

dialog window where you can set Sensitivity,

MD Detection, Output, Record, Buzzer,

Prerecord, Email.

CHANNEL: Select the channel you need to setup.

SWITCH: Each channel has a corresponding

channel switch, press [Enter] to turn on or turn off

the motion detection for each channel.

SENSITIVITY: Each channel has a corresponding

sensitivity setting; including eight standards and

“1” indicates highest sensitivity, press˰Enter˱to

switch.

MD AREA: Sometimes you need to have some regions in your camera view with the enabled

motion detection feature, while other regions in the same view should be free of this

functionality. This may be handy when, for example, the camera covers the road and an

adjoining territory. While you would like to have the motion detection working on the area near

the entrance to the building, you most likely would not like to see it triggered every time a car

or truck passes on the nearby road.

Each channel has a corresponding regional motion detecting setting, move the cursor to