User's Manual

3.3.1 How to pair the wireless camera (transmitter) and wireless DVR (receiver)

Before shipment of this product has been paring ID code, you can instantly use. If you

want to re-pair your code, you have to comply with the following instructions to the paring

code. Please see the follow pairing operation.

After connecting the video output of the wireless DVR and the video input of TV or monitor with a video

cable then the first remove two waterproof plastic caps on the rear of the wireless camera, and preset

channel what you want by sliding manual DIP switch (see page 9), and then cover the waterproof plastic

cap tightly. Turning on the power switch of wireless camera, wireless DVR and TV or monitor, and then

you can press the PAIR button on the rear of the wireless DVR and not release until 3 seconds. The TV or

monitor screen will show “ Please press paring button of TX device “, and then countdown to 17 seconds,

meaning that in 17 seconds, you have to press the paring button on the rear of the wireless camera (TX

device), otherwise it will show “ Pairing failed ”. When you press the paring button on the rear of the

wireless camera and not release until the Power indicating LED on the front of the wireless camera begins

to flash then you can release the PAIR button, and then the wireless camera starts to enter the pairing state

and automatically link ID code to the wireless DVR. When the paring is successful, The TV or monitor

screen will show “ Paring OK Save data “, and the Power indicating LED of the wireless DVR will be lit

directly. That means they have completed the pairing of work, and you can watch the video was transmitted

by the wireless camera on the TV or monitor screen, and then cover another waterproof plastic cap tightly..

When the wireless camera has not been paring ID code, the Power indicating LED should light up until the

60 seconds will automatically go out, and not paring code again unless re-paring once again.

Note:

1. When you use a set the wireless camera and wireless DVR which has a

pairing ID code, if you turn on the wireless camera and wireless DVR, you

will find the Power indicating LED will light for 3 seconds, then off, and it

will automatically start to link between the wireless camera and wireless

DVR. If it has been paired, the Power indicating LED will be lighting, and

then you will be able to watch the video on the TV or monitor screen. If it has

not been paired and also not find the pairing object, it will show “ Link

failed ” on the TV or monitor screen.

2. Because the use of the environment, here may be interference from many

wireless devices, so when you find equipment not working properly, please

turn the wireless camera and DVR on once again.