Use and Care Manual

Triple Tanks Operation Panel Diagram
Introduction of Function and Set Parameters
Single Tank
1. Press“Mixing” key, turn on the mixing function, and the mixing light is on. Press “Mixing” key
again to turn off the mixing function.
2. Press the “Cold Drink” key (the mixing function must be turned on, otherwise the Cold Drink key
will not work), turn on the cold drink function, and the cold drink light is on (the compressor is
powered on) or the cold drink light flashes (compressor is powered off), then press the “Cold Drink”
key again to close the cold drink function.
3. Press the“Slush” key (the mixing function must be turned on, otherwise the Slush key will not
work) to open the slush function, and the slush light is on (the compressor is powered on) or the slush
light flashes (compressor is powered off), then press the “Slush” key again to close the slush function.
4. Press the“Lighting” key to turn on the light, and then press the “Lighting” key again to turn off
the light.
5. Press "Set” key, enter the user parameter setting state. At this time, press th“Set” key to change the
setting object, press“Subtract(-)”key and“Add(+)” key to change the value. After 5 seconds
without operating the key, the system will exit and save the setting value automatically.
6.Hold down “Subtract(-)”key and“Add(+)”key for 5 seconds at the same time to enter the Factory
parameter setting mode, press the“Lighting” key to change the object, and press“Subtract(-)”key
and“Add(+)”key to change the value. The system will exit and save the parameters automatically
after 5 seconds without any operation of keys.
Double Tanks
1.Press “Left Mixing” key, turn on the left mixing function, the left mixing light is on. Press “Left
Mixing” key again to turn off the left mixing function.
2. Press “Right Mixing” key, turn on the right mixing function, and the right mixing light is on. Press
“Right Mixing” key again to turn off the right mixing function.
3. Press the “Cold Drink” key (the mixing function must be turned on, otherwise the Cold Drink key
will not work), turn on the cold drink function, and the cold drink light is on (the compressor is
powered on) or the cold drink light flashes (compressor is powered off), then press the “Cold Drink”
key again to close the cold drink function.
4. Press the “Slush” key (the mixing function must be turned on, otherwise the Slush key will not
work) to open the slush function, and the slush light is on (the compressor is powered on) or the slush
light flashes (compressor is powered off), then press the “Slush” key again to close the slush function.
09