Use and Care Manual

Clean the removed outlet parts in
clean water.
Note: if there is a large amount of
raw material or liquid residue in the
tank, do not disassemble the
material outlet parts, or the tank
parts.
3.Remove the tank parts
Disassembling the tank is the most basic operation to ensure the thorough cleaning. Please follow
the following steps to remove the tank.
A:Remove the tank cover.
B:Hold the discharge outlet by hand and
lift the front end of the tank up, so that
the front end of the tank is stuck, which
is higher than the limit of the tank seat.
C:Gently push the tank forward from the back
end of the tank to remove the tank.
D:Remove the stirrer, the bell mouth sealing
ring and the rear sealing ring of the tank.
Drip Tray
Stuck position-limit position
Stirrer
Bucket rear sealing ring
Bell mouth sealing ring
Clear water
15