Use and Care Manual

5. Press the “Lighting” key to turn on the light, and then press the “Lighting” key again to turn off
the light.
6.Press “Set” key to enter the user parameter setting state. At this time, press the “Set” key to
change the setting object, and press “Subtract(-)” key and “Add(+)” key to change the value. After
5 seconds without operating the key, the system will exit and save the setting value automatically.
7.Hold down “Set” key and “Add(+)” key for 5 seconds at the same time to enter the Factory
parameter setting mode, press the "Set” key to change the object, and press “Subtract(-)” key and
"Add(+)” key to change the value. The system will exit and save the parameters automatically after
5 seconds without any operation of keys.
Triple Tanks
1.Press “Left Mixing” key, turn on left mixing function, and the left mixing light is on.
Press “Left Mixing” Key again to turn off the left mixing function.
2. Press “Mid Mixing” key, turn on the mid mixing function,and the mid mixing light is on.
Press “Mid Mixing” key again to turn off the mid mixing function.
3. Press “Right Mixing” key, turn on the right mixing function,and the right mixing light is
on. Press “Right Mixing” key again to turn off the right mixing function.
4. Press the “Cold Drink” key (the mixing function must be turned on, otherwise the
Cold Drink key will not work), turn on the cold drink function, and the cold drink light is
on (the compressor is powered on) or the cold drink light flashes (compressor is powered
off), then press the “Cold Drink” key again to close the cold drink function.
5. Press the “Slush” key (the mixing function must be turned on, otherwise the Slush key
will not work) to open the slush function, and the slush light is on (the compressor is
powered on) or the slush light flashes (compressor is powered off), then press the Slush key
again to close the slush function.
6. Press the “Lighting” key to turn on the light, and then press the “Lighting” key again
to turn off the light.
7. Press "Set” key to the enter the user parameter setting state. At this time, press the
“Set” key to change the setting object, and press “Subtract(-)” key and “Add(+)” Key
to change the value. After 5 seconds without operating the key, the system will exit and
save the setting value automatically.
8.Hold down “Subtract(-)” key and “Add(+)” key for 5 seconds at the same time to
enter the Factory parameter setting mode, press the “Set” key to change the object, and press
“Subtract(-)” key and “Add(+)” key to change the value. The system will exit and
save the parameters automatically after 5 seconds without any operation of keys.
Notice: when machine works well, please do not change the factory settings.
Alarm Code Description
1) "- -": Frozen bowl alarm. The compressor and motor will stop working, and resume
automatically after 10 minutes.
2)"RH": Temperature sensor malfunction alarm. Stop cooling in cold drink function state
without affecting slush function.
3)"LLL": Low voltage alarm -- the whole machine stops. Turn off the power and check the
power supply. Restart machine after voltage is stable. If it show “LLL” frequently, we
suggest you connect a voltage stabilizer.
10