Use and Care Manual

Power Requirements
The cabinet is intended for connection to an alternating current. The connection voltage (V)
and frequency (Hz) are shown on the nameplate in the cabinet .The power connection is made
using a three-pin plug to a wall socket.Any requirement for earthing from the local power
supply must be met.The cabinet plug and wall socket should then give a correct earthing. If
you are in doubt, contact your local supplier or authorized electrician.
Warning - This appliance must be earthed
The flexible cord fitted to this appliance has three cores for use with a 3-pin 13
Amp plug.If a B.B.1363( 13 Amp) fused plug is used, it should be fitted with a 13 Amp fuse or a
mould-ed right-angled Schuko plug. Note the plate with a hole in it between and above the two
pins - this connects to French and Belgian sockets, which have an earth pin that sticks
out.Running in a slot coming from that plate is a continuation strip from the plate. Other
European countries use a socket with a scrolled metal connector emerging from the side which
mates with that strip. This ensures that the Schuko can be used in most mainland European
countries.
Important
The wires in this mains lead are coloured in accordance with the following code:
Green-and-yellow: earth
Blue: neutral
Brown: live
The colours of the wires in the mains lead of this appliance might not correspond with the
coloured markings identifying the terminals in your plug. Proceed as follows;
The wire which is coloured green-and-yellow must be connected to the terminal in the plug
which is marked "E", marked by the earth symbol or coloured green-and-yellow. The wire,
which is coloured blue , must be connected to the terminal, which is marked with the letter
“N” , or coloured black. the wire which is coloured brown must be connected to the terminal
which is marked with the letter "L " or coloured red.
Troubleshooting
If your Refrigerator, Freezer appliance develop a fault, please check the following table.
Fault
Probable Cause
Action
The appliance is not working
The unit is not switched on
Check that the unit is plugged
incorrectly and switched on
Plug and/or lead are
damaged
Call our agent or qualified
technician
Power supply
Check power supply
Internal wiring fault
Call our agent or qualified