Use and Care Manual

Location and Installation
The cabinet should be placed in a room that is dry and sufficiently ventilated.To
operate efficiently it should not be positioned in direct sunlight or near warm
appliances.Please note that optimal cabinet performance is obtained at an ambient
temperature between 60.8
℉
and 95
℉
.
Freezer,Refrigerator: By placing the cabinet in an environment with high air humidity, it may be
necessary to acquire extra equipment for evaporation of the drip water in the pan near the
compressor.
The cabinet can be installed freestanding against a wall.
Important
The cabinet must have sufficient ventilation and free air circulation beneath, above and behind
the cabinet. The legs under the cabinet will help ensure sufficient air space.
 Remove the appliance from the packaging.Make sure that all protective plastic film and
coatings are thoroughly removed from all surfaces.To prevent injury or damage to the unit,
we recommend that the appliance should be unpacked and set up by two people.
 The appliance should be placed on a solid level floor to reduce noise and vibration.Level the
appliance by adjusting the screw feet,
 Check that the power supply and voltage used comply with the details on the rating
plate.The plug must be accessible after installation
 Correctly connect and disconnect the plug. When inserting ensure the plug is fully engaged.
When unplugging do so by holding the body of the plug. Never pull the supply cord directly.
 If the appliance is to be shut down for long period, switch it off and disconnect the plug
from socket outlet. Clean the appliance and leave the door open to prevent odour.
 Important！ For your personal safety, this appliance must be properly grounded (earthed).
This appliance is equipped with a cord having a grounding wire with a grounding plug.The
plug must be inserted into an outlet that is properly grounded and installed.Consult a
qualified electrician or service center if you do not completely understand the grounding
instructions. If doubt exits as to whether the appliance is properly grounded, have a
qualified electrician check the circuit to make sure the outlet is properly grounded.
 If the cable does not reach the nearest socket, either rearrange your store layout or ask a
qualified electrician to fix a new socket.
 If power is cut off, wait for at least 3 minutes before restarting the appliance to avoid
damaging the compressor.
Note:If the unit has not been stored or moved in an upright position, let it stand upright for
approximately 12 hours before operation.
Note: Before using the appliance for the first time, clean the shelves and interior with soapy
water.