Use and Care Manual

Check Surface Burners
Push and turn a knob to the IGNITE
position.A clicking sound indicates
proper operation of the ignition
system.When lighting any burner,sparks
will appear at all burners but gas flows
from only the one selected.Once air is
purged from the supply line,burner
should light within 4 seconds.After
burner lights,rotate the knob out of the
IGNITE position.Try each burner in
succession until all burners have been
checked.
Quality of Flames
Determine the quality of flames
visually.Normal burner flames
should look like(A) or (B).
(A)Soft blue flames-
Normal for natural
gas
(B)Yellow tips on
outer cones-
Normal for propane
gas
Long,bright yellow flames are not
normal.Normal flames may show signs of
an orange tint when well heated or signs
of flickering orange due to particles in the
gas or air.
Warning!!!
The timer is only used as a reminder function and does not cut off the gas. Please
close the valve in time after the bell rings！
9