FIRE OR EXPLOSION HAZARD If the information in these instructions is not followed exactly,a fire or explosion may result causing property damage,personal injury or death. Read these instructions completely and carefully. When installing a gas appliance the use of old flexible connectors can cause gas leaks and personal injury.Always use a new flexible connector. MATERIALS YOU MAY NEED ■Gas line shut-off valve ■Pipe joint sealant, resists action of natural and propane gases.
MAINTAIN THE FOLLOWING MINIMUM CLEARANCE DIMENSIONS 2
MAINTAIN THE FOLLOWING MINIMUM CLEARANCE DIMENSIONS 3
MAINTAIN THE FOLLOWING MINIMUM CLEARANCE DIMENSIONS 4
5
CONVERTING TO PROPANE GAS(OR CONVERTING BACK TO NATURAL GAS FROM PROPANE) This cooktop leaves the factory set for use with natural gas. The conversion orifices and instructions can be found attached to the regulator.Keep these instructions and all orifices in case you want to convert back and natural gas. Take off the burner cap and the aluminum cap, then use suitable instrument for replacing the nozzle “J”.
Pressure Regulator Installation A:Cooktop air pipe joint B:Pressure Regulator C:Gas fitting D:End of fitting with 1/2 BSP male thread First,make sure that the pressure regulator arrow points toward the cooktop air pipe Joint,and then fasten the pressure regulator to the cooktop air pipe. Then install the gas fitting on the other side of the pressure regulator.
Electric Connections Shock Hazard:This appliance must be properly grounded.Failure to do so can result in electric shock. Electrical Requirements--110-120volt,60Hz,properly grounded circuit protected by a 15-amp or 20-amp circuit breaker or time delay fuse.It is recommended that a separate circuit serving only this cooktop be provided. NOTE:Use of automatic, wireless, or wired external switches that shut off power to the appliance are not recommended for this product.
Quality of Flames Determine the quality of flames visually.Normal burner flames should look like(A) or (B). Check Surface Burners Push and turn a knob to the IGNITE position.A clicking sound indicates (A)Soft blue flames- proper operation of the ignition Normal for natural system.When lighting any burner,sparks gas will appear at all burners but gas flows (B)Yellow tips on from only the one selected.
Adapting To Different Types of Gas Before carrying out any maintenance work,disconnect the appliance from the gas and electric supply. To change the nozzles of burners use the following procedure: Lift up the burners and unscrew the nozzles using an adjustable spanner of 7mm and change the nozzles(Picture “J”) with those designed for the new gas supply according to the information shown below.
Matters Needing Attention A. Before installation,along the inside of the four edges of the cooktop, paste sponge strips to buffer the friction between the cooktop and the cabinet panel. B. Ignition:If there is no electric current you can light the burners with matches. C. When cooking food with oil or fat which can easily set alight,the user must not leave the cooktop.Do not use sprays near the cooktop when it is in use.
K. Cleaning of the enameled parts:to maintain the features of the enameled parts they must be cleaned frequently with soapy water.Never use the abrasive powders.Avoid leaving acid or alkaline substances on the enameled parts(vinegar,lemon juice,salt,tomato juice etc.) and washing the enameled parts when they are still warm. L. Cleaning of the stainless steel parts:clean the parts with soapy water and then dry them with a soft cloth.
