Installation Guide

Error Digital Display
Information
Error Reason How to fix
E1 – Water Inlet Fault
E2 – Drainage Fault
E3- Top Cover Fault
E4 – Spin Fault
E5 – Water Level Fault
Remarks
E6 – Child Protection
Incoming water has taken over 20 minutes to
reach water level.
The Inlet Valve is blocked or obstructed.
The Water supply is cut off or the stopcock is
open.
Check the reason for low water pressure, open
and close the cover 1 time to restart operation.
Remove the blockage from the inlet valve,
once done open and close the cover 1 time to
restart operation.
Turn on the water supply or stopcock , once
done open and close the cover 1 time to
restart operation.
Reposition the drain pipe for a more
smooth water drainage, once done open
and close the cover 1 time to restart
operation.
Remove the blockage from the drain
valve, once done open and close the
cover 1 time to restart operation.
Reposition the clothes in the tub so they
are balanced and level and close the
cover.
Place the washing machine on a level
surface, once done please open and
close the cover.
Unplug the machine, wait 10 seconds
and replug the machine. If issue
continues set water level to normal and
restart the machine.
Ensure that your child is a safe distance
from the machine and close the cover.
If unsolved the problem after use above methods, please contact maintenance dept and processional
maintenance personnel, customer can not assemble or disassemble.
Close the cover.
Water drainage has taken over 5 minutes.
Drain valve blocked, damaged or faulty.
Drain pipe is damaged.
The cover is open during use.
Clothes are not level or balanced.
The machine is standing at an incline.
Water level sensor fault.
Water Leakage.
Harness contact is loose.
Airway tube is loose.
Machine is Child locked but the cover has been
opened.
Parts and Bom Read Before Use
Inner case
Impeller
Operation board
Body
Filter
Adjust nut
Back cover
Power cord
Water input valve
Drain pipe
Handle
Fixed nut
All operation with this Mark must operate
strictly as instruction requirements, or it may
cause machine damage or endanger users' life.
All behavior with this Mark must absolutely
prohibited. or it may cause machine damage or
endanger users' life.
Connect this side to the water
input valve
Connect this side to
the water pipe and
a tap
Connect this side to the
water pipe