Installation Guide
Safety 
! WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR 
INJURY TO PERSONS, OBSERVE THE FOLLOWING: 
 Use this unit only in the manner intended by the 
manufacturer. If you have questions, contact the 
manufacturer at the address or telephone number listed in 
the warranty.
 Before servicing or cleaning unit, unplug or disconnect the 
range hood from the power supply.
 This appliance is not intended for use by persons (including 
children) with reduced physical, sensory or mental 
capabilities, or lack of experience and knowledge, unless 
they have been given supervision or instruction concerning 
use of the appliance by a person responsible for their safety.
 Installation work and electrical wiring must be done by a 
qualified person(s) in accordance with all applicable codes 
and standards, including fire-rated construction.
 Sufficient air is needed for proper combustion and 
exhausting of gases through the flue (chimney) of fuel 
burning equipment to prevent back drafting.
 When cutting or drilling into a wall or ceiling, do not damage 
electrical wiring and other hidden utilities.
 Ducted fans must always be vented to the outdoors.
 Ensure the requirements of the local authorities are adhered 
to concerning the discharge of exhaust air.
 This unit must be grounded.
 When applicable local regulations comprise more restrictive 
installation and/or certification requirements, the 
aforementioned requirements prevail on those of this 
document and the installer agrees to conform to these at his 
own expense.
 Clean range hood frequently. Grease should not be allowed 
to accumulate on fans, filters or in exhaust ducts.
Warning: Failure to install the screws or fixing device in 
accordance with these instructions may result in electrical 
hazards.
3










