Operation Manual

12
MP1524BT
29. RESET Button
The reset button is located behind the SD cover on the front panel. Press to
reset the unit’s settings to factory default.
30. SD Card Interface Connector
The connector is located behind the SD cover on the front panel. The
connector is used to accept an SD card for playback of audio les.
REMOTE CONTROL
Remote Control Battery Installation
The remote control comes with a battery already installed with a Pull Tab to
prevent battery discharge. Remove the Pull Tab before attempting to use the
remote.
NOTE: The remote control will only operate the unit. It is not a universal remote
control and will not control other equipment.
1. While holding the remote control, insert thumbnail into the battery door side
notch (1) and place nger nail into battery door upper notch (2) and slide
battery holder open.
2. Install one CR2025 battery (3).
NOTE: Make sure that the proper polarity (+ or -) is observed.
3. Slide the battery holder back into the remote control until it locks.
Protective Pull Tab (Clear Plastic)
CR2025
3V
(1)
(2)
(3)