Operation Manual

MP1514BT

REMOTE CONTROL OPERATION

Battery Installation

The remote control comes with a battery already

installed with a Pull Tab to prevent battery discharge.

Remove the Pull Tab before attempting to use the

remote control.

Note: The remote control will only operate this device.

It is not a universal remote control and will not

control other equipment.

To replace the battery:

1. While holding the remote control, insert your

thumbnail into the battery door side notch (1) and

index ngernail into battery door upper notch (2).

Slide the battery holder open.

2. Install one CR2025 battery (1).

Note: Make sure that the proper polarity (+ or -) is

observed.

3. Slide the battery holder back into the remote control until it locks.

Remote Control

Back View

Protective Pull Tab (Clear Plastic)

(1)

(2)

CR2025

(1)