Use and Care Manual

E-6
BLUETOOTH OPERATION
Pairing a Bluetooth enabled device with the JWM-160.
1. Tap the POWER / SLEEP button (#1) to turn the unit ON.
2. Tap the BAND/BT button (#2) to select Bluetooth mode, “bt” will show on the LCD Display.
The BLUETOOTH INDICATOR (#10) will begin flashing slowly.
3. Turn on the Bluetooth function for the device you want to link to, and enable the search or
scan function to find the JWM-160.
4. Select "JWM-160" from the device list when it appears on your device screen. If required,
enter the pass code “0000” to pair (link) JWM-160 with your device.
5. If you are pairing (linking) your computer to the speaker using Bluetooth, you may need to
set the JWM-160 as your computer’s default sound device.
6. After successfully pairing the JWM-160 with your Bluetooth device, The BLUETOOTH
INDICATOR (#10) will flash twice per 4 seconds.
7. If you want to pair (link) the JWM-160 with another Bluetooth device, press and hold
/SNOOZE
Button (#6) a few seconds. The
BLUETOOTH INDICATOR (#10) will flash
slowly. The JWM-160 will go into Pairing/Discoverable mode. Repeat steps 3 & 4.
Now you can play music from your Bluetooth device wirelessly to the JWM-160.
1. Selecting your favorite song, press the Play
Button
on your Bluetooth device or the
/SNOOZE
Button (#6)
on the JWM-160 to play or pause the song from your
Bluetooth device.
2. Press button (#5) or button (#7) to select the Previous or Next track.
3. Press VOLUME +/- buttons (#9/8) of your JWM-160 and your Bluetooth device until you
reach a comfortable listening level.
Notes :
1. Refer to the manual of your cell phone, tablet PC, computer or other Bluetooth enabled
devices for Bluetooth operation since it may vary from model to model.
2. If your Bluetooth enabled device does not support A2DP profile, it will not play the music
through the speaker, even if paired (linked).
3. Remember to turn off the JWM-160 when you have finished listening.
4. Don't forget to switch off the power of your external audio device as well.
5. The music playback will automatically be paused when you have an incoming call. When
the call is ended the JWM-160 will start playing again.
USING JWM-160 AS A HANDS-FREE SPEAKERPHONE
To use your Bluetooth speaker as a speakerphone for receiving a phone call from a Bluetooth
enabled phone.
1. Follow the “BLUETOOTH OPERATION” section to set up the Bluetooth connection with
your smartphone.
2. When a call is received while music is playing, the music will be replaced by a tone. Press
the
Play/Pause
/SNOOZE
Button (#6)
once to answer the call.
3. Use the VOLUME +/- buttons (#9/#8) to adjust the desired volume level.
4. To ignore an incoming call, simply press and hold the
Play/Pause
/SNOOZE
Button
(#6)
for about 3 to 4 seconds, a beep sound will be heard and the call was ignored.
5. When the call is completed, press the
Play/Pause
/SNOOZE
Button (#6)
once to
end the call. If you were playing music from the JWM-160 before answering the call, the
music will automatically resume playing when you hang up.