Owner's Manual

INSTALLATION
Basic Installation Steps
Step 1: Remove existing speaker.
Step 2: Position new speaker and align with existing mounting holes.
Step 3: Attach the positive(+) and negative (-) speaker terminals
(see FIGURE 2) . Be sure to observe proper polarity when connecting the wires
(the striped wire is the negative lead) .
FIGURE 1 - DOOR PANEL INSTALLATION
FIGURE 2 - CONNECTING SPEAKER WIRES
Grille
Speaker Door Panel
• Connect the speaker outputs from the head unit to the speakers.
• In some vehicles. it may be possible to utilize the existing speaker wiring. When doing
this. be cautious of the polarity(+/-) of the speaker wires. as these wire colors vary for
each vehicle.
Tip: Using factory wiring harness adapters for the head unit and speakers can help
eliminate wiring issues.
• In some vehicles. it may be necessary to run new speaker wire throughout the vehicle.
Observe caution when routing wires .
• Always use quality connectors that fit tightly. or solder each connection. It may be
necessary to waterproof connections made inside door panels.
• Wiring speakers out-of-phase (the polarity of one speaker is wrong) will cause the
speakers to sound poor. and have very little bass response.
3