MP3 CD System Instruction Manual

E-7 E-8
FOR TABLE TOP USE
FOR WALL MOUNTING
1. Use the wall-mountingtemplate supplied withthe unittomake marks on the wall for the anchors. Make s ure
themarksarelevel.
2. Drill 1/4" holes on the marks. P lease refer to the a ppendix s heet a ttached with this ins truction manual
for details.
3. Ins ert the plas tic anchor s upplied with unit until it is flush with the wall.
4. I ns e rt the s c re w a nd tighte n the s c rew 4mm away from the wa ll. (A pproxima tely the width of 2 pe nnies )
H a ng the main unit a nd s pea ke rs to the s cre w a s indica ted below:
GETTING STARTED
SPE AKER CONNE CTION
1. Insertthe speaker cables by pushingdown the terminallever ofthe LeftSpeaker Terminal and the Right
Speaker Terminal(25).
2. C onnect the s peaker to S peaker Terminals (25), with red wire to red terminals a nd black wire to black
termina ls .
LINE IN (AUX IN) CONNECTION (OPTIONAL)
1. C onnect the left and right channel R C A plug (not included) into the AUX IN J ack (21) and the other end
to your external player. Make s ure the polarity of the right and the left channel is correct, Red to Right, White to Left.
2. Press the
Following the diagrams below, insert the stands into the base and attach the main unit and
speakers as shown.
NOTE: A screwdriver is needed for attacking the stands to the main unit and stands.
ON/STANDBY Button (10/H1) to switch on the unit.
3. Press Function Button (3/H3). “AUX” Indicator (#D5) appears in the display (18).
4. Play the auxiliary input source.
SUBWOOFER CONNECTION (OPTIONAL)
1. Connect one end of a RCA plug (not included) into the Subwoofer Jack (24) and the other end to the
subwoofer (not included).
2. Turn on the unit and then your subwoofer.
ANTENNA CONNECTION
FM: Unwrap and fully extend the FMAntenna wire (22) for best reception. If stereo broadcasting is received,
Stereo Indicator (#D15) will light.
AM: The unit is built-in with a directional ferrite antenna, reposition the unit for best reception.
POWER SUPPLY
This Front Loading Dual CD System operates from AC120V~60Hz line power supply.
The remote control unit operates on one 3V “CR2025” lithium battery. To power up the remote control, remove the
plastic insulation tab sticking out of the battery compartment.
AC POWER CONNECTION
Connect the power cord to an AC120V~60Hz power source.
REPLACING BATTERYIN THE REMOTE CONTROL
1. Turn over the remote control, and remove the battery door.
2. Install 1 “CR2025” lithium battery according to the polarity diagram
on the battery compartment.
3. Replace the battery door.
INSTALLATION
JMC-670 INSTRUCTION MANUAL JMC-670 INSTRUCTION MANUAL
HX-1056M3 IB JENS 001 REV0.P65 7/20/2005, 2:51 PM5