® DOCKING SPEAKER STATION FOR iPad, iPod AND iPhone USER MANUAL JiPS-290i (iPod/iPhone/iPad Not Included) PLEASE READ THIS USER MANUAL COMPLETELY BEFORE OPERATING THIS UNIT AND RETAIN THIS BOOKLET FOR FUTURE REFERENCE.
DEAR JENSEN® CUSTOMER Selecting fine audio equipment such as the unit you've just purchased is only the start of your musical enjoyment. Now it's time to consider how you can maximize the fun and excitement your equipment offers. This manufacturer and the Electronic Industries Association's Consumer Electronics Group want you to get the most out of your equipment by playing it at a safe level.
IMPORTANT SAFETY INSTRUCTIONS When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1.
IMPORTANT NOTES For best iPad display clarity, avoid operating the unit in the direct sunlight or under bright light. Avoid installing the unit in locations described below: Places exposed to direct sunlight or close to heat radiating appliances such as electric heaters. Places subject to constant vibration. Dusty, humid or moist places. Sources of electrical noise such as fluorescent lamps or motors. NOTE: when the system is switched to standby mode, it is still consuming some power.
PRODUCT FEATURES The JiPS-290i is an iPad / iPod / iPhone Docking Music System with incorporates the following features: Play and Charge Your iPad, iPhone, iPod nano, iPod touch. Player Only for Your iPod classic and iPod video Auxiliary input jack. Stereo speakers with subwoofer. Video Line-out Connector. GETTING STATRTED 1. STANDARD ACCESSORIES Carefully remove all the accessories from the display carton.
REMOTE CONTROL "CR2025 type" lithium battery The remote control works on one 3V (included). To active the remote control, remove the insulation tab inserted in the battery compartment. To remove the tab, pull it in the direction of the arrow as shown in the illustration. If the operation of the remote control becomes unsatisfactory, replace the original battery with a new 3-volt lithium battery of the same type. 1. Slide out the battery holder from the remote control case.
1.) Adjustable Support for iPad/iPod/iPhone 2.) Speaker Grill 3.) Remote Control Sensor TOP PANEL OF THE UNIT 3.) 4.) 5.) 6.) VOLUME Down (-) Button VOLUME Up (+) Button POWER ON/STANDBY; iPod/AUX FUNCTION select Button iPad/iPod/iPhone Dock Connector REAR PANEL OF THE UNIT 7.
.) AUX IN Jack 9.) Composite Video Out Connector REMOTE CONTROL 1.) POWER ON/STANDBY Button 2.) iPod MENU UP Button 3.) PLAY / PAUSE Button 4.) SKIP/FAST BACKWARD Button 5.) ENTER Button 6.) SKIP/FAST FORWARD Button 7.) iPod MENU Button 8.) iPod MENU DOWN Button 9.) FUNCTION Button 10.) VIDEO ON/OFF Button 11.) MUTE Button 12.) VOLUME Up (+) Button 13.) VOLUME Down (–) Button OPERATING INSTRUCTIONS BASIC OPERATION Turning on/off the unit 1).
Volume Up( + ) / Down( - ) control Press the VOLUME Up(+) / Down(-) button on the remote control or main unit to adjust the volume to desired sound level. Operating the MUTE function When listening to an iPad/iPod/iPhone or while using the AUX IN, press the MUTE button on the remote to activate the mute function, the blue rings around the POWER and VOLUME Up/Down Buttons will begin flashing rapidly. The speaker sound is temporally muted.
Adjust the position of the support by turning the barrel shaped knob (located on the back of the assembly) either clockwise or counter-clockwise until the front padded part of the barrel touches the back of your iPad, iPod or Phone. The barrel shaped knob will move forward or back as it’s turned. The Apple device should be angled slightly backwards to secure the docking.
iPad/iPod/iPhone PLAYBACK (By Remote Control): Press the PLAY/PAUSE button to pause or resume the iPad/iPod/iPhone playback; or buttons to skip to the next or previous song; Press the SKIP or buttons for fast-forwarding or fast-rewinding during Press and hold the SKIP playback. From the remote, press the MENU button, ENTER button and / buttons on the remote control to control the iPod menu, scroll menu up/down and enter selection. Note: 1.
Note: MEMU / buttons on the remote control may not work for your iPad. 7. The video can be switched between the local Apple device screen (default) and Video-out by pressing VIDEO ON/OFF button and then select a video from video library to play. Note: 1). If you are using iPad, you can simple press the VIDEO ON/OFF button and then Play/Pause button to switch video play back on iPad’s screen or TV. 2).
CARE AND MAINTENANCE 1. 2. Avoid operating your unit under direct sunlight or in hot, humid or dusty places. Keep your unit away from heating appliances and sources of electrical noise such as fluorescent lamps or motors. 3. For better Clock Display clarity, avoid operating the unit under direct sunlight or in strong room illumination. 4. Unplug the unit from the electrical power outlet immediately in case of malfunction.
Volume level is set too high. Sound source is distorted. If the iPad/iPod/iPhone original sound source is of poor quality, distortion and noise are easily noticed with high-power speakers. Try a different audio source such as a music CD. If you are using an external sound source like older generation of iPod, try reducing the output volume on the device itself. Also try turning bass boost OFF or change the EQ setting. This is normal. Turn the unit off for a period of time or lower volume.
90 DAY LIMITED WARRANTY AND SERVICE VALID IN THE U.S.A ONLY SPECTRA MERCHANDISING INTERNATIONAL, INC. warrants this unit to be free from defective materials or factory workmanship for a period of 90 days from the date of original customer purchase and provided the product is utilized within the U.S.A. This warranty is not assignable or transferable.
