® DOCKING DIGITAL MUSIC SYSTEM FOR iPod AND iPhone USER MANUAL JiMS-125i (iPhone/iPod Not Included) PLEASE READ THIS USER MANUAL COMPLETELY BEFORE OPERATING THIS UNIT AND RETAIN THIS BOOKLET FOR FUTURE REFERENCE.
DEAR JENSEN® CUSTOMER Selecting fine audio equipment such as the unit you've just purchased is only the start of your musical enjoyment. Now it's time to consider how you can maximize the fun and excitement your equipment offers. This manufacturer and the Electronic Industries Association's Consumer Electronics Group want you to get the most out of your equipment by playing it at a safe level.
IMPORTANT SAFETY INSTRUCTIONS When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1.
13. This appliance shall not be exposed to dripping or splashing water and that no object filled with liquids such as vases shall be placed on the apparatus. 14. Power Sources – The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. Do not overload wall outlet. 15. Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. 16.
Protect Your Furniture This product is equipped with non-skid rubber 'feet' to prevent the product from moving when you operate the controls. These 'feet' are made from non-migrating rubber material specially formulated to avoid leaving any marks or stains on your furniture. However certain types of oil based furniture polishes, wood preservatives, or cleaning sprays may cause the rubber 'feet' to soften, and leave marks or a rubber residue on the furniture.
LOCATION OF CONTROLS 1. POWER On/Standby button 2. MEMORY SET/CLOCK ADJUST button 3. ALARM 1 button 4. iPhone/iPod docking connector 5. ALARM 2 button 6. FUNCTION button 7. SKIP FORWARD / TUNING UP button 8. VOLUME- (DOWN) button 9. VOLUME+ (UP) button 10. SNOOZE/SLEEP/DIMMER button 11. SKIP BACK / TUNING DOWN button 12. iPod PLAY/PAUSE / FM Memory Up button 13. Display 14. DC IN Jack 15. AUX IN Jack 16. FM Wire Antenna (back of unit) 17.
GETTING STARTED Clock Back-up Battery Installation 1. Remove the screw from the BATTERY COMPARTMENT COVER and remove the cover. 2. Install a CR2032 lithium battery (not included) in the battery compartment following the polarity markings shown on it. 3. Replace the BATTERY COMPARTMENT COVER and tighten the screw to secure the compartment.
2. Your iPod/iPhone will communicate with the unit and automatically sync the time with your iPod/iPhone time and show it on the LCD Display after about 5 seconds. Tips: The iPhone receives constant updates from the phone service provider, so the iPhone time will always be accurate. The time on your iPod was undated with your computer the last time the iPod was attached and synced with it.
5. Press the or button to adjust the minute. Press and hold the button for fast advance / reverse setting. 6. Press the ALARM 1 or ALARM 2 button to confirm the minute setting, the alarm sound icons will flash. 7. Press the or button to select the wake up option (iPod, Beep, Radio). 8. Press the ALARM 1 or ALARM 2 button again to complete the alarm setting. The or will appear to indicate it is enabled. alarm indicator 9.
The iPod / iPhone alarm will sound for 60 minutes and then turn off automatically if no snooze button pressed. To stop the iPod / iPhone sound immediately, tap the button. Snooze Function When the alarm sounds, it can be temporarily stopped by pressing the SNOOZE button. The display will show the relative alarm indicator or flashing. The alarm will be delayed for 9 minutes and then come again. This manual snooze operation can be repeated again within one hour. LISTENING TO RADIO 1.
the “P01” indicator will show on the LCD. Preset channel number “01” is flashing. 5. Press the or button to select the preset number you want to assign the station to. 6. Press the MEM.SET/CLK.ADJ. button to confirm the setting. 7. Repeat above steps 3-6 to store other stations. RECALLING PRESET MEMORY CHANNELS In radio mode, recall the pre-set channels by pressing the MEM+ button on main unit repeatedly.
button for five seconds to switch off the device and then gently remove it from the docking connector. 8. Press the POWER button to turn off the unit. CHARGING Your iPhone/iPod will charge in all function modes when docked. NOTE: To prevent damaging of the dock connector, never twist the iPhone/iPod when inserting or removing it. DIMMER In Standby mode, press the DIMMER button to adjust the LCD backlight intensity from High/Low /Mid to obtain the best clarity of LCD Panel readout.
3. Turn on the external audio device. 4. To select auxiliary audio input, press the FUNCTION button to select AUX mode. 5. The volume level can now be controlled through the main unit. Operate all other functions on the auxiliary device as usual. NOTE: If you connect this unit to the Line-Out Jack of your external device then you only need to adjust the volume control of this unit.
TROUBLESHOOTING GUIDE Symptom The unit does not respond (no power) Unit is ON but there is low or no volume iPod / iPhone does not dock properly Possible Problem The unit is disconnected from the AC outlet. The AC outlet has not power. The volume control has been turned all the way down. Using no/wrong iPod / iPhone Adaptor. iPod / iPhone not installed properly. iPod / iPhone is not installed properly. iPod / iPhone does not respond to the speaker system Your iPod / iPhone is locked up.
Unit gets warm after This is normal. extended play at high volume Turn the unit off for a period of time or lower volume. SPECIFICATION Power requirement: AC-DC adaptor Input: AC 120V~, 60Hz Main Unit Backup Battery for Clock DC Input: DC 5V, 2000mA 1 X 3V CR2032 Lithium Battery Frequency Range Radio Band FM 87.
90 DAY LIMITED WARRANTY AND SERVICE VALID IN THE U.S.A ONLY SPECTRA MERCHANDISING INTERNATIONAL, INC. warrants this unit to be free from defective materials or factory workmanship for a period of 90 days from the date of original customer purchase and provided the product is utilized within the U.S.A. This warranty is not assignable or transferable.
