Installation Guide

7. Before proceeding to the next step, test the fit of
the side mirrors. Carefully, place one side mirror
between the body and the wall, making sure that
enough space is allocated for the mirror. Remove
the mirror and test the other side with the other
mirror.
8. With the bath cabinet mounted securely on the
wall, attach the side mirrors. First, mount the
Styrofoam blocks included in your kit. Place the
block on each side of the cabinet as shown in
Diagram (H1). Note: for 34" cabinets you will
mount two Styrofoam blocks on each side of your
cabinet as shown in diagram (H2). Remove the
protective strip from one side of the block and
place the tacky side to the body. Press firmly to
ensure proper adhesion. Once the blocks are
attached, remove the protective strip from all the
tape pieces located on the blocks and the bracket
and mount the mirrors on each side. Be sure the
mirror is aligned to the top and bottom of the
cabinet and the wall before pressing in place. Press
firmly on the mirror to be sure that it is securely
attached to the mounting brackets.
9. After the cabinet is mounted and the side
mirrors attached position the loosely attached
mirror clips one at a time so the bent edge of
the clip rests against the front of the side
mirror and tighten the screw to hold the clip
securely in place.
10. Install hinges. Mount hinge unit on door as
shown in Diagram (I1 & I2) with screws provided.
11. Install the door by inserting door side of the
hinge into the bracket on the body as shown:
a) 170 degree Hinge: Insert door side of clip hinge
as shown in Diagram (I3).
b) 125 degree Hinge: Slide hinge arm on to the
bracket and tighten mounting screws as shown in
Diagram (I4).
12. Check door for proper alignment. If the door
needs to be adjusted please refer to the adjustment
procedures in Diagram (J1 & J2). Door edges
should be aligned with the edges of the body and
should fit evenly to the face of the body. Optional:
To allow the door to open to 170 degrees, remove
the limit clip shown in Diagram (J1). This option
only applies to units with 170 degree hinges.
13. Install shelves as directed below:
a) Select where you want the shelves to be placed.
b) Insert two shelf brackets for each end of the
shelf at the desired locations.
c) Set shelves in place on the shelf brackets.
Diagram (K).
C99043073 G
The mirror clips provide additional
side mirror attachment support and
should be used in addition to and NOT AS
A REPLACEMENT for the mirror
attachment method with tape per the
current mirror mounting instructions.
Rangaire Manufacturing Company, LP · 501 S. Wilhite Street, Cleburne, TX 76031
(1-800-325-8351) · www.rangairemfg.com